RIGOL RP1002C

Current Range

50mV/A, 500mV/A

DC Accuracy, typical

500mV/A: ±3% ±20mA

(20mA to 14A peak range)

50mV/A: ±4% ±200mA

(200mA to 100A peak range)

50mV/A: ±15% maximum

(100A peak to 140A peak range)

Gain versus frequency, typical

See Appendix 1 Gain versus

Frequency at 1 A Peak (Typical)

Max. Working Current

SeeVoltage and Current Ratings

Max. Working Voltage

SeeVoltage and Current Ratings

Max. Floating Voltage

SeeVoltage and Current Ratings

Frequency Range

DC to 1MHz (-3dB)

Battery Type and Life, typical 

9V NEDA 1604A, IEC 6LR61

8 hours (1 each)

DC Signal Linearity, typical

See Appendix 3 DC Signal

Linearity in 50mV/A Range (Typical)

Phase versus frequency, typical

See Appendix 4 Phase versus

Frequency at 1 A Peak (Typical)

Parameter

Max. Working Current (A)

Max.

Working

Voltage

(V)

Max.

Floating

Voltage

(V)

50mV/A

Range

500mV/A

Range

DC

70[1]

7

600

600

DC+AC

Peak

70[1]

7

600

600

AC Peak

70

7

600

600

AC

Peak-peak

140

14

1200

----

RMS     CAT

III

50

5

600

600

RMS CAT II

50

5

600

600

RMS CAT I

50

5

600

600

Dimensions

262mm x 81mm x 36mm

Max. Conductor under test Size

10.3mm

Dual-BNC Coaxial Cable Length

100cm

Weight

310g (battery excluded)  

Working

Temperature

0℃ to +50℃

Storage

Temperature

-20℃ to +80℃

Humidity

0℃ to +40℃, 95% humidity

+40℃ to +50℃, 45% humidity

Pollution Degree

2 

EC Declaration of Conformity – Low Voltage 

Low Voltage Directive 73/23/EEC, as amended by 93/68/EEC

Low Voltage Directive 73/23/EEC, as amended by 93/68/EEC

EN 61010-1/A2:1995: Safety requirements for electrical equipment for measurement, control and laboratory use - Part 1: General requirements.

EN 61010-2-032:1995: Safety requirements for electrical equipment for measurement, control and laboratory use - Part 2-032: Particular requirements for hand-held current clamps for electrical measurement and test.

Additional Compliance

IEC61010-1/A2:1995: Safety requirements for electrical equipment for measurement, control and laboratory use - Part 1: General requirements.

IEC61010-2-032:1994: Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 2-032: Particular requirements for hand-held current clamps for electrical measurement and test.

Installation

(Overvoltage)

Category 

CAT III: Equipment in a fixed industrial location (usually permanently connected)  CAT II: Equipment at this level includes appliances, portable tools, and similar products. Equipment is usually cord-connected. 

CAT I: Secondary (signal level) or battery operated circuits of electronic equipment.