Hioki PQ3100 KIT

Hioki PQ3100 Kit Highlights

• Voltage, current: ch1, ch2, ch3, ch4 / power : ch1, ch2, ch3
• Fundamental frequency: DC/ 50 Hz/ 60 Hz
• Measurement lines: 1-phase/ 2-wire, 1-phase/ 3-wire, 3-phase/ 3-wire, 3-phase /4-wire + Ch. 4
• Voltage Input:
  • Number of channels: 4, U4: Not isolated
  • Maximum terminal-to ground rated voltage: 1000 V (measurement category III), 600 V (measurement category IV)
• Current input:
  • Power supply for sensors
  • 4 Channels
• Measurement parameters:
  • Voltage:
    • 1/2 RMS value (half-wave offset wave calculation), RMS value, waveform peak, unbalance rate (Voltage DC), frequency (1 wave/ 200 ms/ 10 sec.)
    • Crest factor
  • Current:
    • Inrush current (half-wave), RMS value, waveform peak, unbalance rate (reverse phase/forward phase), K factor, Current DC
    • 1/2 RMS value (half-wave offset wave calculation), crest factor
  • Power:
    • Active power, reactive power, apparent power, power factor, displacement power factor, active energy, reactive energy
    • Apparent energy, electrical charges
  • Flicker: Support for flicker measurement planned with a future firmware update.
  • Harmonics: 0th order (DC) to 50th order, voltage/current/power, phase angle (voltage/current), voltage/current phase difference, total harmonic distortion ratio (voltage/current)
  • Inter-harmonics: 0.5th order to 49.5th order, voltage/current
• Circuit management - Record power quality on the utility grid
• Equipment malfunctions - Analyze issues with power supplies
• DC Power - Measure AC/DC power
• Settings are a breeze with QuickSet - Launch QuickSet to navigate everything from connection procedures to wiring checks and measurement settings on the instrument’s screen.
• External power supply not required - The PQ3100 powers all sensors, eliminating the need to use AC adapters. Flexible current sensors provide a convenient way to make measurements in tight spaces, including power supply circuits with double and triple wiring.
• Complete recording of normal recovery - Where legacy models only recorded post anomaly waveforms for 1 sec., the PQ3100 extends recordings to 10 sec. The ability to also record 1 sec. before the anomaly occurred is useful when you need to analyze waveform characteristics before and after the event.

Each Hioki PQ3100 KIT Includes

• 600A clamps
• Voltage Cord L1000-05 × 1 set
• USB cable (length: 1 m) × 1
• Spiral tube × 5
• AC Adapter Z1002 × 1
• User’s manual and measurement guide × 1 each
• Color spiral tubes (red, blue, yellow) × 2 each
• Battery Pack Z1003 × 1
• PQ One (application software on CD-R) × 1
• Strap × 1